24 / 7
 
+7 (812) 970-30-05
+7 (960) 283-57-59
m@trubogib.ru

trubogib.ru since 1993

 

ABOUT US
TUBE BENDING MACHINES
TUBE BENDING TOOLS
OTHER PRODUCTS
CONTACTS

Our typical Products

The products we manufacture traditionally include hydraulics, mechanics, electronics, and related software.

Our range of products includes both serial products and special machines designed and manufactured to order. Of the series production, our pipe bending machines are the most widely known.

Pipe benders can be viewed in the corresponding section of this site. A few examples of different nodes can be seen here:

If you have any questions, you can always contact us.

Non-standard equipment

Throughout its history, our specialists have developed and produced a number of special non-standard products. These products have been successfully operated at various latitudes in various regions - from the sea shelf to high-altitude regions, both under the control of operators and remotely and automatically.

These products had a narrow purpose and were not intended for general consumption.

At the same time, we have developed such units as a system for high-speed precision dosing of liquid media (with automatic adaptation to the hydrodynamic and thermophysical characteristics of the liquid), ultra-precise positioning hydraulic drives, compact high-torque (up to 250,000 N*m) rotary hydraulic drives, etc.

Our company occupies a leading position in a number of automatic control systems for mechanical objects.

Development to order

We can undertake the development and manufacture of complex special machines and devices required by the customer. A variety of situations are possible that force the use of non-serial equipment, but usually the following circumstances lead to this:

  • the required equipment does not exist in principle;
  • similar equipment exists but is offered at an unacceptably high price;
  • similar equipment exists but does not meet the requirements for reliability, integrability into the general production system, etc.

We use the most efficient design and simulation tools.

We believe that for successful project implementation, the separation of design and manufacture is justified only in cases where when either design or manufacture is completely standard, requiring no research or experimentation for example, in construction, where the builder and the architect are traditionally separated. In complex works in the field of mechanical engineering and instrument making, we believe such a division is inappropriate since it leads to delaying deadlines and blurring responsibility. Therefore, we are always ready to offer our customers a turnkey job.

Each order, of course, must be carefully discussed. Traditionally, we try to attract the customer as much as possible to participate at all stages of work, from the formation of all the details of the technical assignment to the testing of individual units and the product as a whole.

Since we are historically focused on research and development, the organization of our work often allows you to achieve the desired result at a relatively low cost.

And as a result of your work, you will receive not just a project, but a completely finished product capable of solving your problems.


+7 (812) 970-30-05     +7 (960) 283-57-59     m@trubogib.ru